Results
Q1. You are flying a Cessna with registration VT-ADR. On first call you say:
Correct answer is – Victor Tango Alpha Delta Romeo
Q2. The phrase “WILCO” means:
Correct answer is – Will comply
Q3. The squawk code 2000 is transmitted as:
Correct answer is – Squawk two thousand
Q4. The frequency 118.100 MHz should be transmitted as:
Doubt full qustion —– in question bank Correct answer is – One one eight decimal one zero zero
Q5. Flight Level 180 should be transmitted as:
Correct answer is – Flight level one eight zero
Q6. Which of the following should be avoided during transmission?
Correct answer is – Hesitation sounds such as “er”
Q7. You are assigned to contact Delhi Approach for sequencing to land. Which suffix is correct?
Correct answer is – APPROACH
Q8. The suffix ‘TOWER’ is used for which service?
Correct answer is – Aerodrome control
Q9. ALL STATIONS’ at the start of a transmission means:
Correct answer is – Talking to all stations that may receive the message
Q10. If ATC calls an aircraft, the pilot must reply within:
Correct answer is – 5 seconds
Q11. What is the full form of MET in civil aviation?
B
Q12. What is the meaning of AGL in aviation?
B
Q13. The standard pronunciation of numeral 5 is:
Correct answer is – Fife
Q14. The primary purpose of standardized ICAO phraseology in radiotelephony communications is:
Correct answer is – To ensure clarity, brevity, and prevent ambiguity
Q15. In radiotelephony, the phrase “DISREGARD” means:
Correct answer is – Ignore the previous message
Q16. ICAO’s abbreviation for Aeronautical Information Publication is:
A
Q17. The transponder code 4203 should be transmitted as:
Correct answer is – Squawk four two zero three
Q18. Which is a Type C full call sign?
Correct answer is – AIC 101
Q19. The abbreviation ATC means:
C
Q20. According to ICAO, when should the word “IMMEDIATELY” be used in radiotelephony communication?
Correct answer is – Only during urgent safety situations requiring instant action
Q21. You are a SpiceJet aircraft operating as SG 402. Which type of call sign is this?
Correct answer is – Type C
Types of Call Sign
TYPE A
Characters corresponding to the registration marking of the aircraft
| Category | Example 1 | Example 2 | Example 3 |
|---|---|---|---|
| Full Call Signs | N59826 or VTESC | CESSNA VTKMC or CESSNA N 59826 | CITATION VTKMC or CITATION N59826 |
| Abbreviated Call Signs | N826 or N26 VSC or VESC | CESSNA MC or CESSNA KMC CESSNA 826 VMC26 | CITATION MC or CITATION KMC CITATION 826 |
TYPE B
Telephony designator of the aircraft operating agency, followed by the last four characters of the registration marking
| Category | Example |
|---|---|
| Full Call Signs | AIR INDIA VTESC |
| Abbreviated Call Signs | AIR INDIA SC AIR INDIA VSC |
TYPE C
Telephony designator of the aircraft operating agency, followed by the flight identification
| Category | Examples |
|---|---|
| Full Call Signs | AIC 111 IGO 2234 SEJ 2034 AKJ 1350 SPJ 1466 GO 611 |
| Abbreviated Call Signs | NO ABBREVIATED CALL SIGNS |
Quick Aviation Notes (Exam-Oriented)
- Type A → Pure registration-based call sign
- Type B → Operator partial registration
- Type C → Operator flight number (most common in airline ops)
- Abbreviation rules apply mainly to Type A & B, not Type C
Q22. In radiotelephony, the numeral 3 is pronounced as:
Correct answer is – Tree
Q23. Which of the following words may be omitted from transmissions if no confusion will occur?
Correct answer is – “Surface” (in relation to wind), “Degrees” (in radar headings), “Visibility” in MET reports
Q24. GROUND’ is the suffix for:
Correct answer is – Surface movement control
Q25. Which abbreviation refers to the flight plan that has been filed?
B
Q26. The correct way to transmit the frequency 118.025 MHz is:
Correct answer is – One one eight decimal zero two five
Q27. How is the altitude 3,400 feet transmitted?
Correct answer is – Three thousand four hundred
Q28. Visibility of 4500 meters is transmitted as:
Correct answer is – Visibility four thousand five hundred
Q29. What does the abbreviation SID mean in aviation?
A
Q30. Which statement is correct about the language to be used in radiotelephony (RTF)?
Correct answer is – The station on the ground may use the language normally used by that station, but English must also be available upon request
Q31. Which is a Type A full call sign?
Correct answer is – VT-KMC
Q32. PRECISION’ suffix is used for:
Correct answer is – Precision approach radar
Q33. A heading of 080 degrees should be transmitted as:
Correct answer is – Heading zero eight zero
Q34. What is the maximum recommended speech rate for transmissions?
Correct answer is – 100 words per minute
Q35. What does the abbreviation RVR stand for?
B
Q36. ATC transmits: ‘All stations, Delhi Control…’. Who is this call intended for?
Correct answer is – All stations within range
Q37. During first contact, a pilot should:
Correct answer is – Use full call sign
Q38. Under ICAO provisions, when ICAO standard phraseology is not sufficient for a situation, pilots and controllers should:
Correct answer is – Use plain language or appropriate subsidiary phraseologies clearly and concisely
Q39. What does DGCA stand for?
Directorate General of Civil Aviation
Q40. Your full call sign is Air India VT-LOP. This makes it which type?
Types of Call Sign
TYPE A
Characters corresponding to the registration marking of the aircraft
| Category | Example 1 | Example 2 | Example 3 |
|---|---|---|---|
| Full Call Signs | N59826 or VTESC | CESSNA VTKMC or CESSNA N 59826 | CITATION VTKMC or CITATION N59826 |
| Abbreviated Call Signs | N826 or N26 VSC or VESC | CESSNA MC or CESSNA KMC CESSNA 826 VMC26 | CITATION MC or CITATION KMC CITATION 826 |
TYPE B
Telephony designator of the aircraft operating agency, followed by the last four characters of the registration marking
| Category | Example |
|---|---|
| Full Call Signs | AIR INDIA VTESC |
| Abbreviated Call Signs | AIR INDIA SC AIR INDIA VSC |
TYPE C
Telephony designator of the aircraft operating agency, followed by the flight identification
| Category | Examples |
|---|---|
| Full Call Signs | AIC 111 IGO 2234 SEJ 2034 AKJ 1350 SPJ 1466 GO 611 |
| Abbreviated Call Signs | NO ABBREVIATED CALL SIGNS |
Quick Aviation Notes (Exam-Oriented)
- Type A → Pure registration-based call sign
- Type B → Operator partial registration
- Type C → Operator flight number (most common in airline ops)
- Abbreviation rules apply mainly to Type A & B, not Type C
Q41. The QNH setting of 1000 hPa is transmitted as:
While many pressure settings are transmitted digit by digit, the 1000 hPa value is spoken as “One Thousand”
Q42. When transmitting time, usually:
Correct answer is – Only minutes of the hour are required
Q43. The call sign ‘Indigo Dispatch’ belongs to:
Correct answer is – Company dispatch
Q44. How should the runway designation 09 be transmitted?
Correct answer is – Runway zero nine
Q45. While on the take-off roll, ATC calls you with a clearance change. Is this normally allowed?
Correct answer is – No, unless for safety reasons
Q46. The abbreviation IFR stands for:
A
Q47. The abbreviation for VT-AUM after first contact could be:
Correct answer is – Victor Uniform Mike
Q48. If the RVR is 1700 meters, it is transmitted as:
Correct answer is – RVR one thousand seven hundred
Q49. Your aircraft registration is VT-POH. After establishing contact with ATC, what is a correct abbreviated call sign you can use?
Correct answer is – Victor Oscar Hotel
Example : VT-AKC
First transmission (full): Victor Tango Alpha Kilo Charlie
Subsequent: Victor Kilo Charlie
Q50. Runway 27 should be transmitted as:
Correct answer is – Runway two seven
Q51. If ATC cannot identify the calling station, they will say:
Correct answer is – “Station calling… say again your call sign”
Q52. You are flying into Mumbai and are cleared to land. After landing, ATC asks you to contact surface movement control. Which station will you call?
Correct answer is – Mumbai Ground
Q53. You are given instructions to contact Mumbai Radar after departure. This service is for:
Correct answer is – Radar monitoring and control
Q54. The abbreviation VFR means:
A
Q55. ATC calls: ‘Station calling Chennai, say again your call sign’. What does this mean?
Correct answer is – They could not identify who is calling
ATC Phrase: “Station Calling Chennai, Say Again Your Call Sign”
This phrase is used by an Air Traffic Control (ATC) station when they have received a transmission directed to them, but they are uncertain of the identification of the calling aircraft.
Breakdown of the Phrase
- “Station calling Chennai”:
ATC uses this phrase when they did not hear or could not understand the identity of the calling aircraft. It is a general call addressed to the unknown station. - “Say again your call sign”:
The standard radiotelephony phrase SAY AGAIN means “Repeat all, or the following part, of your last transmission.” ATC is specifically requesting the pilot to repeat their call sign for proper identification.
Correct Pilot Response
If you receive this call from ATC, you should respond by stating the facility name followed by your full aircraft call sign.
Example:
“Chennai, Fastair 345”
